Response SA5 E Instruções de Operação Página 19
- Página / 52
- Índice
- MARCADORES
Avaliado. / 5. Com base em avaliações de clientes
19
INSTALLING AND CONFIGURING THE
SOLAR SIREN
Ensure that the system is in Test mode (see page 13).
1. Remove the xing screw from the bottom edge of
the Siren housing and carefully hinge off the front
cover. Hold the mounting plate in position and mark the
positions of the four mounting holes. A spirit level placed
on the casing will ensure a perfect level.
2. Drill four 6mm holes and t the wall plugs.
3. Fit the two 30mm xing screws in the top holes
leaving approximately 10mm of the screw protruding.
4. Fit the top keyhole slots of the mounting plate over the
screw heads. Remove the mounting plate and adjust the
screws until they form a neat t with the mounting plate
with minimal movement.
5. Secure the mounting plate in position using the two
25mm xing screws in the bottom xing holes.
6. Ensure that the Siren’s main conguration switch on
the LED indicator board is set to “SIREN” for use with
this alarm system.
7. Undo the three screws holding the DIP Switch Cover
in place and remove the cover.
8. Under the cover you will nd a series of 9 DIP
switches.
Note: When the Siren is viewed as shown above (Solar
panel at top) the DIP switches are ‘upside down’.
9. DIP switches 1-8 are used to set the House Code
for the Siren and must be set to the same ON/OFF
combination as all other system devices.
10. If required the maximum length of time that the
Siren will sound for when activated under an alarm
condition may be limited to 3 minutes using DIP switch
9 as follows:
ON as Control Panel setting
OFF limited to 3 minutes
11. The Siren will acknowledge Disarm signals from the
Remote Control and Service Mode signals by beeping.
It is possible to disable these acknowledgement beeps
if required by removing the jumper link P2 on the circuit
board.
P2 tted Beep enabled
P2 removed Beep disabled
- 6 Zone Communicating 1
- Wirefree Alarm System 1
- Tools and Equipment Required: 2
- CONTENTS 3
- KIT CONTENTS 4
- INTRODUCTION AND OVERVIEW 5
- button on their 6
- 7
- 7
- 7
- TYPICAL INSTALLATION 8
- REMOTE CONTROL UNIT 9
- Testing the Remote Control: 10
- INSTALLING THE CONTROL PANEL 11
- Inside View of Control Panel 11
- At the Control Panel: 12
- Using a Remote Control: 12
- PASSIVE INFRA RED (PIR) 13
- MOVEMENT DETECTORS 13
- PIR DETECTOR 14
- Testing the PIR Detector: 15
- 1 2 3 4 5 15
- MAGNETIC CONTACT 16
- DETECTORS 16
- + side is uppermost on each 17
- EXTERNAL SOLAR SIREN 18
- SOLAR SIREN 19
- . 20
- User Access Code 21
- FACTORY SETTINGS 23
- Master User Access Code 24
- LEARN SYSTEM HOUSE CODE 27
- ALARM DURATION 27
- to save and exit, or 28
- RINGS TO ANSWER PHONE 29
- DIALLER DELAY 29
- DIAL METHOD 29
- DIAL MODE 29
- ZONE SETUP 30
- FINAL EXIT SET 31
- ENTRY DELAY 31
- Delay Period 31
- PART-ARM 1 32
- PART-ARM 2 32
- WALK THROUGH 32
- TELEPHONE NUMBERS 33
- ALARM MESSAGE PLAY TIME 34
- RECORD ALARM MESSAGES 34
- REPLAY ALARM MESSAGES 34
- CALL ROUTING 34
- TEL CONFIRM TIMES 34
- EXIT-DELAY PERIOD 35
- ENTRY-DELAY BEEPS 35
- EXIT-DELAY BEEPS 35
- CALL ATTEMPTS 35
- TIME & DATE SETUP 38
- LATCH KEY SETUP 38
- 39
- ANSWERPHONE ON/OFF STATUS 39
- TELEPHONE NUMBER: 40
- REPLAY ANSWERPHONE GREETING 40
- OPERATING INSTRUCTIONS 41
- LEAVING A VOICE MEMO MESSAGE 43
- External Answerphone: 43
- Control Panel 45
- Remote Control 45
- PIR Movement Detector 45
- Magnetic Contact Detector 45
- MAINTENANCE 46
- ALARM RECORD 47
- Symptom / Recommendation 48
- EXTENDING YOUR ALARM SYSTEM 50
- GUARANTEE 50
- 01268 563273 52
Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Response SA5 E
(24 páginas)© 2020, manymanuals-pt.com. Todos os direitos reservados. | 0.042 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais