Response SA5 E Instruções de Operação descarregar pdf (Página 17)

3. If xing the detector with screws, rst remove the

battery holder by carefully tilting up the end and pulling

away from the printed circuit board (PCB).

The top of the Detector is secured by hanging the

keyhole slot over the head of the 10mm pan head

screw. The bottom of the Detector is secured using the

12mm counter-sunk head screw tted within the battery

compartment. Carefully drill out the centre of the xing

screw hole in the battery compartment using a 3mm

drill. Fit the Magnet using the two 15mm xing screws.

Do not over tighten the screws as this may distort or

damage the casing.

4. If an additional wired Magnetic Contact is required,

this should be wired to the terminal block provided in

the battery compartment. The wired contact should be

connected using a maximum length of 1.5 metres of

any of the following:

- 6 core alarm cable

- 2 core bell wire (6 x 0.2mm minimum)

- 2 core 24AWG wire

A cable entry cut-out is provided beside the terminal

block in the battery cover.

If an additional wired contact is connected to the

detector then jumper Link S2 on the Circuit board must

be removed.

IMPORTANT: If an additional wired contact is not

connected, then the Jumper Link S2 must be tted

for the Detector to operate correctly.

5. Congure the House Code for the Magnetic Contact

Detector by setting DIP switches 1-8 to the same ON/

OFF combination as the House Code DIP switches in

all other system devices.

6. Congure the alarm zone which the detector will

operate on with DIP switches 9-11 as follows:

DIP 9 DIP 10 DIP 11

Zone 1 OFF OFF OFF

Zone 2 OFF OFF ON

Zone 3 OFF ON OFF

Zone 4 OFF ON ON

Zone 5 ON OFF OFF

Zone 6 ON OFF ON

e.g. To congure the detector to operate on zone 2 set

DIP switches 9,10 and 11 as follows:

Note: DIP switch 12 is not used.

7. Slide the two batteries supplied into the battery

holder, ensuring that the + side is uppermost on each

battery as it is installed.

8. If necessary, ret the battery holder into the detector

ensuring that the spring clip connectors slide onto

either side of the circuit board.

9. Ret the battery cover.

Testing the Magnetic Contact Detector:

10. Use the and buttons to scroll through

the menu until ‘WALK TEST’ is displayed and press

. .

‘Walk Test Waiting…’ will be displayed.

11. Remove the battery cover to activate the tamper

switch.

As the button is released the LED indicator will

illuminate for approximately 1 second to show that the

tamper switch has been triggered and a signal is being

transmitted.

In addition, the Control Panel will beep to indicate that

an alarm signal has been received and ‘Accessory

















2 3 4 5 6 7 8 9 10 11 12







































  



1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 51 52

Comentários a estes Manuais

Sem comentários

Response SA5 E Instruções de Operação Página 17

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Response SA5 E