Response SA5 E Instruções de Operação descarregar pdf (Página 14)

When deciding upon the mounting position for the

detector the following points should be considered to

ensure trouble free operation:

1. Do not position the detector facing a window or

where it is exposed to or facing direct sunlight. PIR

Detectors are not suitable for use in conservatories.

2. Do not position the detector where it is exposed to

draughts.

3. Do not position the detector directly above a heat

source, (e.g. re, radiator, boiler, etc.).

4. Where possible, mount the detector in the corner of

the room so that the logical path of an intruder would

cut across the fan detection pattern. PIR Detectors

respond more effectively to movement across the

device than to movement directly towards it.

5. Do not position the detector in a position where it is

subject to excessive vibration.

6. Ensure that the position selected for the PIR

Detector is within effective range of the Control Panel.

7. Do not x the PIR Detector onto or very close to

metalwork (i.e. radiators, water pipes, etc.) as this

could affect the radio range of the device.

Note: When the system is Armed, pets should not be

allowed into an area protected by a PIR Detector as

their movement could be detected and trigger an alarm.

INSTALLING AND CONFIGURING THE

PIR DETECTOR

Ensure that the system is in Test Mode (see page 13).

1. Undo and remove the screw from the bottom edge

of the PIR Detector (keep the screw safe for later).

Carefully pull the bottom edge of the detector away

from the rear cover and slide down to release the top

clips.

2. Carefully drill out the required mounting holes in the

rear cover using a 3mm drill according to whether the

unit is being mounted in a corner or against a at wall.

3. Using the rear cover as a template, mark the

positions of the xing holes on the wall.

4. Fix the rear cover to the wall using the two 18mm

No.4 screws and 22mm wall plugs, (a 5mm hole will

be required for the wall plugs). Do not over-tighten the

screws as this may distort or damage the cover.

Note: The wall plugs supplied with the product are not

suitable for plasterboard walls, if mounting the Detector

onto plasterboard use appropriate wall plugs.

5. Congure the House Code for the PIR Detector by

setting DIP switches 1-8 of SW2 to the same ON/OFF

combination as the House Code DIP switches in all

other system devices.

6. Congure the alarm zone which the detector will

operate on by setting DIP switches 1-3 of SW3 as

follows:

DIP 1 DIP 2 DIP 3

Zone 1 OFF OFF OFF

Zone 2 OFF OFF ON

Zone 3 OFF ON OFF

Zone 4 OFF ON ON

Zone 5 ON OFF OFF

Zone 6 ON OFF ON

e.g. To congure the detector to operate on zone 3 set

DIP switches 1, 2 and 3 of SW3 as follows:

7. DIP switch 4 of SW3 is used to congure the PIR

Detector for Walk Test mode, which overrides the 2

minute sleep period and allows the operation of the

detector to be checked during installation.

ON = Walk Test mode

OFF = Normal Operation

On initial installation the detector should be congured

into Walk-Test mode ready for testing (i.e. with DIP

switch 4 of SW3 ON).

1 2 3 4 5

















1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 51 52

Comentários a estes Manuais

Sem comentários

Response SA5 E Instruções de Operação Página 14

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Response SA5 E