Response SA5 E Instruções de Operação descarregar pdf (Página 16)

MAGNETIC CONTACT

DETECTORS

The Magnetic Contact Set comprises 2 parts; Detector

and Magnet. They are designed to be tted to either

doors or windows with the Magnet mounted on the

opening part of the door/window and the Detector

mounted to the frame.

When the protected door or window is opened and the

Magnet is moved away from the Detector an alarm will

be triggered, (if the system is Armed).

The Magnetic Contact Detector has the facility to

connect an additional wired Magnetic Contact. This

must be of a normally closed contact type with the

contact being opened in order to generate an alarm

condition.

The Magnetic Contact Detector is powered by two

CR2032 type Lithium cells which under normal

conditions will have an expected of approximately 1

year. Under normal battery conditions the LED on

the Detector will not illuminate when the Detector is

triggered, (unless the detector is in test mode with the

battery cover removed). However, under low-battery

conditions this LED will be illuminated for approximately

1 second when the detector is triggered. When this

occurs the batteries should be replaced as soon as

possible.

Any number of Magnetic Contact Detectors can be

used with the system, providing they are all coded with

the same system House Code and are mounted within

effective radio range of the Control Panel.

POSITIONING THE MAGNETIC CONTACT

DETECTORS

The Magnetic Contact Detector is suitable for mounting

in dry interior locations only.

Decide which doors and windows are to be protected

by tting Magnetic Contact Detectors, (usually the

front and back doors as a minimum will have Magnetic

Contact Detectors tted). However additional detectors

may be tted where required to other more vulnerable

doors or windows, (e.g. garage, patio/conservatory

doors etc.).

Ensure that the position selected for the Magnetic

Contact Detector is within effective range of the Control

Panel.

Do not x the Detector onto or very close to metalwork

(i.e. radiators, water pipes, etc.) as this could affect the

radio range of the device.

On PVC Door/Window frames, it may be necessary to

space the Detector and Magnet away from the metal

surface using a plastic or wooden spacer to achieve

the necessary radio range.

INSTALLING AND CONFIGURING THE

MAGNETIC CONTACT DETECTORS

Ensure that the system is in Test mode (see page 18).

1. Remove the battery cover by sliding and lifting it off.

(DO NOT use a screwdriver to lever it off).

2. The Detector and Magnet should be mounted

together along the opening edge of the Window/Door

opposite the hinges. Ensure that the parallel gap

between the Magnet and Detector is less than 10mm

and that the arrow on the magnet is aligned with the

mark on the detector.

The Detector should be mounted on the xed part of

the frame and the Magnet on the opening part.

The Detector and Magnet should be mounted using the

double sided adhesive pads or screws provided.

Note: If mounting the device using the adhesive pads

ensure that the mounting surfaces are clean and dry

before mounting.



























1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 51 52

Comentários a estes Manuais

Sem comentários

Response SA5 E Instruções de Operação Página 16

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Response SA5 E