Response RE3000S Instruções de Operação descarregar pdf (Página 20)

9. EXIT DELAY TONE

During the Exit delay period the Control Unit may be

set to either remain silent or to give an intermittent

bleep tone.

With the Control Unit in Programming mode Enter

Zone 1 LED will indicate the setting:-

LED ‘ON’ - intermittent bleep delay tone selected

LED ‘OFF’ - silent exit delay selected.

Factory default:-

intermittent bleep tone ON - Zone 1 LED ‘ON’.

Press to select silent exit delay

Press to select intermittent bleep delay tone.

Press to memorise the setting and revert to the

Programming mode.

10. QUICK ARM/PART ARM

Quick Arm allows the Control Unit to be Armed or

Part Armed by simply pressing and holding the Arm

or Part Arm key for 5 seconds removing the need to

enter an access code first.

With the Control Unit in Programming mode Enter

Zone 1 LED will indicate the setting:-

LED ‘OFF’ - Quick Arm ‘OFF’

LED ‘ON’ - Quick Arm ‘ON’

Factory default:-

Quick Arm OFF - Zone 1 LED ‘OFF’

Press to select Quick ARM ‘ON’

Press to select Quick ARM ‘OFF’

Press to memorise the setting and to revert to

the Programming mode.

11. JAMMING DETECTION SYSTEM

In order to detect any attempts to jam the radio channel

used with your alarm system a sophisticated Jamming

Detection system is incorporated into the Control Unit.

If this feature is selected and the radio channel is

continuously jammed for more than 30 seconds the

Control Unit sounder will emit a Pre Alarm series of

rapid bleeps for 5 seconds. If the system is Armed and

the Jamming continues for a further 10 seconds or

more; or a total of 30 seconds of Jamming is detected

within a 5 minute period, a full alarm will occur indicated

by the Internal and External alarms sounding, but no

Zone LED’s ON.

The jamming detection circuit is designed to

permanently scan for illegal jamming signals.

However, it is possible that it may detect other

local radio interference operating legally or illegally

on the same frequency. If it is planned to operate

the jamming detection feature we recommend that

the system is monitored for false jamming alarms

for at least 2 weeks prior to leaving the Jamming

Detect function on permanently.

With the Control Unit in Programming mode Enter

Zone 1 LED will indicate the setting:-

LED ‘OFF’ - Jamming Detection System ‘OFF’

LED ‘ON’ - Jamming Detection System ‘ON’

Factory default:-

Jamming Detection ‘OFF’, Zone 1 LED ‘OFF’.

Press to select Jamming Detection ‘ON’

Press to select Jamming Detection ‘OFF’

Press to memorise the setting and to revert to

the Programming mode.

12. SIREN CODE (AND OPTIONAL MEDICAL

ALERT PENDANT CODE)

A small radio transmitter is incorporated within the

RE5000S Control Unit to operate and control the

external Solar Siren & Strobe. To enable the

Control Unit to communicate with the external

Solar Siren & Strobe the Siren Code set in the

external Siren (see page 14) needs to be

programmed into the Control Unit.

The (optional) Medical Alert Pendant(s) to be used

with the system must also be set to the ‘Siren Code’

in order that the pendant radio signal is sent to both

the Control Unit and the external Siren & Strobe,

18 RE5000S Professional Alarm System

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 33 34

Comentários a estes Manuais

Sem comentários

Response RE3000S Instruções de Operação Página 20

Comentários a estes Manuais