Response RE3000S Instruções de Operação descarregar pdf (Página 18)

The Zone LED’s 1-6 will indicate the new ‘House Code’

switch setting selected for each switch 1-6 as follows:-

‘+’ - LED ‘ON’

‘o’ - LED ‘FLASHING’

‘-’ - LED ‘OFF’

Press to memorise the ‘House Code’ setting

and to revert to the Programming mode.

2. INSTANT/DELAY ZONE

Any Zone can be set to give an entry delay when the

appropriate Detector(s) are triggered, eg. to allow

access to the Control Unit for manual disarming. (The

length of the entry delay period is programmed

separately - see 7 below).

With the Control Unit in Programming mode Enter

The Zone LED’s 1-6 will indicate the status of each

Zone:-

Zone LED ‘ON’ = Delay Zone

Zone LED ‘OFF’ = Instant Zone

Factory default:-

Zones 1 and 2 Entry Delay

Zones 1 and 2 LED’s ‘ON’.

To add or delete a Delay Zone, press the number of

the Zone to illuminate or extinguish the appropriate

Zone LED.

Press to memorise the setting and to revert to

the programming mode.

3. EXIT DELAY TIME

When the system is fully armed either at the Control

Unit or via a Remote Control, the system will ignore

all detectors for a preset Exit Delay time, to allow you

to leave the premises.

Note: There is no exit delay when the system is Part

Armed.

With the Control Unit in Programming mode Enter

A Zone LED will illuminate to indicate the setting:-

Factory default:-

30 seconds - Zone 3 LED ‘ON’.

To change the setting, press the appropriate key to

illuminate the associated Zone LED:-

Enter to memorise the setting and to revert to

the Programming mode.

4. ALARM AUTOSTOP TIME

This is the length of time that the alarm will sound for

when activated. A fully silent alarm option is also

available. (If accidentally triggered, the alarm can be

stopped at any time using the Remote Control or by

disarming at the Control Unit keypad).

Note: The maximum length of time that the external

Solar Siren & Strobe will sound for when activated is

set within the Solar Siren & Strobe to either 3 or 15

minutes - refer to “Installing and Setting the External

Solar Siren & Strobe” for details.

With the Control Unit in Programming mode Enter

. A Zone LED will illuminate to indicate

the setting:- (factory default 60 seconds - Zone 2 LED

‘ON’). To change the setting press the appropriate

key to illuminate the associated Zone LED:- (Note no

LED will be illuminated if a silent alarm is selected).

Press to memorise the setting and to revert to

the Programming mode.

5. MAIN USER ACCESS CODE

The Control Unit is supplied with a preset Main User

Access Code of . This

code

allows general operation (Arming/Disarming etc)

AND programming/re-programming of the system at

the Control Unit. However, for security reasons, it is

essential that you change the Main User Access

Code to another four-digit number which only you

and other users of the system will know and use

(usually a number with a personal significance is

easier to remember).

Note: a separate Second User Access Code is also

available which will allow only Arming/Disarming at

the Control Unit. You may therefore wish to allow

16 RE5000S Professional Alarm System

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 33 34

Comentários a estes Manuais

Sem comentários

Response RE3000S Instruções de Operação Página 18

Comentários a estes Manuais