Response SL5 Instruções de Operação descarregar pdf (Página 28)

Using a Remote Control

With the required House Code already

configured, press the button on the

Remote Control.

When the Control Panel receives the signal from

the Remote Control the Panel will beep and the

display will change to show the received house

code on lower line of the display beneath the

corresponding DIP switch numbers (1-8).

Press to save the new setting, or

Press to exit without saving.

Note: Make a note of the system house code now in

the Alarm Record section.

ALARM DURATION

Scroll through the menu until ‘2-2 ALARM TIME’ (and

the current setting) is displayed.

To change the setting press .

On/Off Status

Default setting: ON

Scroll through the menu until ‘2-2-1 Status’ (and

the current setting) is displayed.

To change the setting press .

Press to enable the Siren, or

Press to disable the Siren.

Siren Duration

Default setting: 180s

Scroll through the menu until ‘2-1-2 Time’ (and the

current setting) is displayed.

To change the setting press .

Enter the required alarm duration in units of

10s. e.g. enter 6 for a 60s alarm duration (max

setting 60, i.e. 600s/10mins).

Press to save and exit, or

Press to exit without saving.

Press to return to top level System Setup

menu.

Note: Following an alarm condition the Siren will

continue to sound until either the system is

Disarmed; or the Alarm Duration Time expires. If the

“3 minute alarm time limit” of the Solar Siren is

enabled then the Solar Siren will shut down after 3

minutes even if the panel siren is still operating.

WIREFREE SIREN

Allows the wirefree siren to be enabled or disabled.

Default setting: ON

Scroll through the menu until ‘2-3 Wirefree Siren’

(and the current setting) is displayed.

To change the setting press .

Press to enable the Solar Siren, or

Press to disable the Solar Siren.

JAMMING DETECTION

Allows the jamming detection in the control panel to

be enabled or disabled.

Default setting: OFF

Scroll through the menu until ‘2-4 RF Jamming

Detection’ (and the current setting) is displayed.

To change the setting press .

Press to enable Jamming Detection, or

Press to disable Jamming Detection.

CONTROL PANEL BACK LIGHT

This controls how long the display backlight will

remain illuminated for after a key is pressed.

Default setting: 10s

Scroll through the menu until ‘2-5 Back Light’ (and

the current setting) is displayed.

To change the setting press .

Press to save and exit, or

Press to exit without saving.

ALARM RELAY

This controls the operation of the NO/NC hardwired

output relay contacts following an alarm.

Default setting: “ON Until Disarm

PROGRAMMING

26 SA5

ENTER

ESC

ENTER

ESC

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 51 52

Comentários a estes Manuais

Sem comentários

Response SL5 Instruções de Operação Página 28

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Response SL5