Response SL8 Manual de Instruções descarregar pdf (Página 10)

Control Panel over these screws using the two

keyhole slots in the top corners of the panel

casing.

5. Route the cable from the Power Supply Adaptor

up behind and on the right hand side of the

Control Panel and connect the plug to the DC

power socket in the panel. Ensuring that the cable

is not trapped between the panel and the wall.

6. Fix the Control Panel to the wall using two 18mm

No.4 screws in the lower two fixing holes in the

Control Panel and tighten the upper fixing screws

until they just grip the casing. Do not over-tighten

the screws as this could damage or distort the

casing.

7. Ensure that the Reset Jumper Link (P1) and the

External Tamper Switch Jumper Link (P51) are

set in the OFF position.

8. Connect battery leads to both back-up batteries

and refit batteries.

LEFT Battery: Red lead to the Red (

) battery

terminal

Black lead to the Black (

) battery

terminal

RIGHT Battery: Red lead to the Red (

) battery

terminal

Black lead to the Black (

) battery

terminal

Note: The Power LED may flash to indicate that

the unit is being operated from the back-up

batteries and that mains supply is not present.

9. Close the lid of the Control Panel and fasten the

cover fixing screws.

10. Plug in and switch ON the Power Supply Adaptor,

(the Power LED should illuminate).

LEARNING A NEW REMOTE

CONTROL/KEYPAD

Note: Up to a total of 6 Remote Controls and/or

Keypad Units can be linked to the system.

To link a new Remote Control/Keypad to the

Control Panel:

Place the Control Unit into Learn Mode. With the

system in Standby

Press

The Arm and Part-Arm LEDs will illuminate and all

Zone, Fire and Tamper LEDs will flash together.

1. Press on the Control Panel.

The Tamper LED will flash continuously to

indicate the system is in device learn mode.

The current number of Remote Controls/Keypads

already linked into the system will be indicated on

the zone LEDs. For example if there are three

Remotes/Keypad linked then zone LEDs 1, 2 and 3

will be illuminated.

The panel will now listen for valid signals from new

remote controls or keypads.

OFF ON

Jumper

Link

O. GND V+ OUT GND

External Tamper Switch

Jumper Link P51

Reset Jumper

Link P1

Jumper

Link

Jumper

Link

IMPORTANT: Take care when connecting

battery leads to the batteries as connecting

incorrectly could damage the batteries or the

Control Panel.

ote: If the Control Panel Tamper alarm sounds

uring the installation reset the alarm by pressing

on the Control

Panel.

IMPORTANT: The keys must be pressed firmly

and within 5 seconds of each other. If you make

a mistake, press and start the sequence again.

ENTER

, ,

User Access Code

ENTER

, ,

User Access Code

ESC

Note: The Panel will remain in Learn Mode for

30s. If a valid signal is not received from a new

Remote Control or Keypad within 30s it will

automatically exit Learn Mode and return to the

top level of Program Mode.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 39 40

Comentários a estes Manuais

Sem comentários

Response SL8 Manual de Instruções Página 10

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Response SL8