Response SL5 Manual de Instruções descarregar pdf (Página 16)

On initial installation the detector should be

configured into Walk Test ready for testing,

(i.e. Pressing down SW1 for 2 seconds).

9. Refit the PIR Detector to the rear cover by

offering the detector up to the rear cover and

locate the clips in the top edge into the rear

cover. Push the lower edge of the detector into

place and refit the fixing screw in the bottom

edge of the PIR to secure in position. Do not

over-tighten the screws as this may damage

the casing.

10. Walk into and move slowly around the protected

area within the 5 minutes of pressing SW1.

Each time the detector senses movement the

LED indicator behind the lens will flash.

LINKING A PIR DETECTOR TO THE

CONTROL PANEL

1. Remove the PIR Detector from its rear cover

after installing and configuring it.

2. With the system in Standby

Press

to enter Program Mode.

3. Scroll through the programming menu until

‘3. ZONE SETUP’ is displayed and press .

4. Enter the zone number to be configured (1 - 36)

and press .

‘3-1 ZX Empty’ will be displayed (X = Zone no.)

Note: Zones 33-36 the wired zones are the

same except there is no learn menu option as

these are wired.

5. Press .

6. To learn a new detector ID code and link it to

the selected zone press .

The panel will now listen for a valid signal from

a new detector to link to the zone.

The Panel will remain in Learn Mode for 30s.

If a valid signal is not received from a new

device within 30s it will automatically exit

Learn Mode and return to the top of level 2.0.

7. Activate the Tamper Switch on the PIR detector.

If the detector is new and not already linked on

any security zone the panel will produce two

short beeps and the display will show ‘New

Device’ and the type of device detected (PIR).

8. Confirm the new device ID code by activating

the Tamper Switch on the same new PIR

detector within 15 seconds.

The panel will produce three short beeps and

the LCD will show ‘Device Confirmed’.

The LCD will then show ‘Saving New Device’

while the ID code of the new detector is stored

into memory.

9. Refit the PIR to its rear cover.

10. After completing the Zone Setup press to

return to the top level of programming menu.

Note: Ensure that there is no movement in front of

the PIR for 3 minutes to allow it to stabilise before

entering test mode.

SW1 (Test Mode)

Press for 2 seconds to

activate Walk Test mode

SW3

Sensitivity

Low

SW1

Test Mode

SW2

ENTER

, ,

Installer Access Code

ENTER

Note: If the detector is already linked to the

control panel on any other zone then the

panel will produce a single long beep and the

received signal from the detector will be ignored.

Note: If the confirmation signal is not

received within 15s the control panel will

produce a single long beep and exit the

learning process. The learning process will

need to be started again to learn the new

device into memory.

ESC

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 63 64

Comentários a estes Manuais

Sem comentários

Response SL5 Manual de Instruções Página 16

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Response SL5