Response SA1 E Instruções de Operação descarregar pdf (Página 18)

ARMING THE SYSTEM IN

INSTANT-ARM MODE

The system can be Armed in Instant mode by using

either the Remote Control or the Keypad as follows:

Remote Control:

Press the ‘INSTANT-ARM’ button,

The Siren will acknowledge the signal by beeping once.

Keypad:

Enter your User Access Code followed by the

‘INSTANT-ARM’ button

The Siren will acknowledge the signal by beeping once.

ARMING THE SYSTEM IN

DELAY-ARM MODE

The system can be Armed in Delay mode using either

the Remote Control or the Keypad as follows:

Remote Control:

Press the ‘DELAY-ARM’ button,

The Siren will acknowledge the signal by beeping once

and then again after the 15 second entry/exit period

has expired. The system will not be fully Armed and

active until after the second beep.

Keypad:

Enter your User Access Code followed by either

‘DELAY-ARM’ button.

The Siren will acknowledge the signal by beeping once

and then again after the 15 second entry/exit period

has expired. The system will not be fully Armed and

active until after the second beep.

DISARMING THE SYSTEM

The system can be Disarmed using either the Remote

Control or the Keypad as follows:

Remote Control:

Press the ‘DISARM’ button,

The Siren will acknowledge the signal by beeping

twice.

Keypad:

Enter your User Access Code followed by the ‘DISARM’

button.

The Siren will acknowledge the signal by beeping

twice.

IMPORTANT: If, when the system is Disarmed,

the Siren emits a series of 10 rapid beeps, this

indicates that an Alarm has been triggered whilst

the system was Armed. Check the security of the

property before entering.

PERSONAL ATTACK (PA) ALARM

An Alarm can be immediately triggered by the user at

any time (whether the system is Armed or Disarmed) in

the event of threat or danger by activating the Personal

Attack (PA) facility using either the Remote Control or

the Keypad as follows:

Remote Control:

Slide the Personal Attack switch upwards.

Keypad:

Press and hold both the and buttons

together for 2 seconds.

The Alarm will sound until the set alarm duration time

expires or the system is Disarmed from the Remote

Control or Keypad.

DEVICE TAMPER

If the battery cover of any device (except a Remote

Control) is removed or if the Siren or Keypad are

removed from the wall then an Alarm will immediately

occur (unless the Siren is in Service Mode), even if the

system is Disarmed.

The Alarm will sound until the set alarm duration time

expires or the system is Disarmed from the Remote

Control or Keypad.

? ? ? ?

User Access Code

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24

Comentários a estes Manuais

Sem comentários

Response SA1 E Instruções de Operação Página 18

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Response SA1 E