Response SA1 E PLUS Instruções de Operação descarregar pdf (Página 11)

Note: DO NOT fix the

PIR Detector

to metalwork or

locate the unit within 1m of metalwork (i.e. radiators,

water pipes, etc) as this could affect the radio

range of the device.

Installing and Configuring the

PIR Movement Detector

Ensure that the system is in Service Mode

1. Undo and remove the fixing screw from the

bottom edge of the PIR Detector. Carefully pull

the bottom edge of the PIR Detector away from

the rear cover and then slide down to release

the top clips.

2. Carefully drill the required mounting holes in the

rear cover using a 3mm drill relevant to whether

the PIR Detector is being mounted in a corner or

against a flat wall.

3. Using the rear cover as a template, mark the

positions of the fixing holes on the wall.

4. Fix the rear cover to the wall using the two

18mm No.4 screws and 25mm wall plugs, (a

5mm hole will be required for the wall plugs).

Do not over-tighten the fixing screws as this

may distort or damage the cover.

Note: The wall plugs supplied with the product

are not suitable for plasterboard walls, if

mounting the PIR Detector onto plasterboard

use appropriate wall plugs.

5. Configure the PIR Detector as described in

‘Setting the PIR Detectors’. Remember that on

initial installation the device needs to be tested

and should therefore be set in Walk Test Mode.

6. Check that the PIR Detector PCB is located and

set in the correct position to give the detection

zone pattern required.

To adjust the PCB position, simply slide it up or

down ensuring that the location legs are aligned

with the required position number marked on

the board.

7. To refit the PIR Detector to the rear cover, offer it

up to the rear cover and locate the clips in the top

edge into the rear cover. Push the lower edge of

the PIR Detector into place and refit the fixing

screw in the bottom edge to secure in position.

Do not over-tighten the fixing screws as this may

damage the casing.

Setting the PIR Detector

Located on the PCB of the PIR Detector are two

blocks of DIP switches (SW2 and SW3).

When setting Dip Switches to House Code, hold

the PIR Detector ‘upside down’ as shown in the

diagram below:

1. DIP switches SW2 (numbered 1-8) are used to

set the House Code for the PIR Detector and

must be set to the same ON/OFF combination

as the House Code DIP switches in all other

system devices.

Setting for a Siren only Alarm System

For a Siren only Alarm System, DIP switches 1- 3 of

SW3 must be set as follows:

ear Cover

Fixing Screw

Mounting Hole

Positions

DIP Sw

itches

(SW2 and

SW3)

PCB

Board

(slides

up and

down to

adjust

sition)

ECE

1 2 3 4 5 6 7 8 1 2 3 4 5

SW3

SW2

Set to House Code

Zone

Settings

Walk Test

Sensitivity

DIP 1

DIP 2

DIP 3

OFF

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 27 28

Comentários a estes Manuais

Sem comentários

Response SA1 E PLUS Instruções de Operação Página 11

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Response SA1 E PLUS