Response SL8 Manual de Instruções descarregar pdf (Página 25)

WIRE FREE SIREN TEST

Press

The External Solar Siren will be activated for 5

seconds and then stop.

Zone 2 LED will be illuminated during the test.

INTERNAL SIREN TEST

Press

The Control Panel internal siren will be activated for

5 seconds and then stop.

Zone 3 LED will be illuminated during the test.

WIRED SIREN TEST

Press

The hardwired siren only will be activated for 5

seconds and then stop.

Zone 4 LED will illuminate during the test.

SIREN SERVICE MODE

The Solar Siren includes a Service Mode facility

which prevents the sirens tamper switch from

triggering an alarm while it is removed from the wall

for maintenance or to change the batteries. After

changing the batteries and refitting in position, the

Solar Siren must be put back into Operating Mode,

otherwise it will not sound in the event of an alarm.

For Siren Service Mode ON (Siren Service Mode)

see page 30 for Siren Service Mode OFF (Siren

Operating Mode) see page 31 for details.

FACTORY SETTINGS

ser Access Code: 1 2 3 4

Alarm Duration: 3 minutes

Hardwired Siren: Equal to Alarm Duration

Zone Operating Mode: Intruder (all zones)

Part-Arm: Zones 1-4: Enabled

ones 5-6: Disabled

Instant/Delay: Zone 1: Delay

Zones 2-6: Instant

Entry/Exit Delay: 30 seconds

Entry/Exit Warning Tone: On

Zone Lockout: On

Jamming Detection: Off

Spectra Lighting Status: Off

Spectra Lighting

Time-on period: 3 minutes

RESET FACTORY SETTINGS

1. Press

This puts the system into Test Mode.

2. Undo the Control Panel cover fixing screws and

open the cover.

3. Remove the DC power jack, then remove and

disconnect one of the back-up batteries.

4. Set jumper link P1 to the ON position.

5. Reconnect the power supply jack.

6. The Control Panel will now reset itself with all

factory settings.

7. The Control Panel will beep and the zone 6 LED

will illuminate for 5 seconds and the factory

settings will be restored to memory.

8. Reconnect and replace the back-up battery.

9. Reset jumper link P1 into the OFF position.

10. Close the Control Panel cover and refit the fixing

screws.

NTER

ENTER

, ,

User Access Code

OFF ON

Jumper Link

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 39 40

Comentários a estes Manuais

Sem comentários

Response SL8 Manual de Instruções Página 25

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Response SL8