Response SL5 Manual de Instruções descarregar pdf (Página 6)

The Entry-Delay for each zone may be configured for

between 10 to 250 seconds or disabled completely.

Note: To conserve power and maximise battery life

the PIR Detector will only detect movement if there

has been no movement detected within the previous

2 minutes. Consequently the PIR Detector will not

become active until the protected area has been

free from movement for more than 3 minutes.

ZONES

The system incorporates 32 wireless alarm zones

for the connection of a detector per zone used to

independently monitor different areas of the

property. In addition to standard intruder protection,

each zone can also be configured to operate in

alternative modes.

For example:

– ‘Intruder’ mode provides standard intruder

monitoring.

– ‘24-hour Intruder’ mode provides 24 hour intruder

protection for areas where continuous monitoring

is required, (e.g. gun lockers).

– ‘Fire’ mode provides 24 hour monitoring of any

Smoke detectors incorporated into the system.

–‘Test’ mode allows a zone to be monitored while

the system is armed. If a detector on a zone is

triggered an entry will be recorded in the Event

Log but an alarm will not occur.

In addition there is the facility to connect up to 4

hard wired zones to the Control Panel, each of which

is configurable with most of the features of the

wireless zones.

ZONE LOCKOUT

If a detector on an active zone is triggered while the

system is armed an alarm will sound. After the

programmed alarm duration has expired the alarm

will stop and the system will automatically reset.

Subsequent detectors triggered will again trigger an

alarm. If a single zone triggers an alarm more than

3 times then that zone will be ‘Locked Out’ and any

further alarm signals from that zone will be ignored

until the system is disarmed.

Note: The ‘Zone Lockout’ feature can be disabled

if required.

QUICK SET

The system may be fully armed in 10 seconds using

the quick set facility, overriding the programmed exit-

delay. This is useful for setting the system at night

when the Exit-Delay warning beep will be silenced

after just a few seconds.

EVENT LOG

The Control Panel incorporates a memory capable

of storing the last 99 system events. This enables

the user to see which user has Armed/Disarmed

the system and if and when any alarms occurred.

The time, date and details of the event type will be

recorded for each system event.

CHIME

Chime is a low security facility for use when the

system is in Standby mode. If the Chime feature is

ON, and a detector on a zone that has its Chime

function enabled is triggered, the internal sounder

will produce a low volume warning tone. A typical

use of the Chime function would be to warn that a

door or particular area has been entered.

MONITORING (OPTIONAL)

This system incorporates a telephone dialler (Voice

Dialler) and monitoring service (Remote Manager).

The monitoring service enables the system to make

a check call to the premises and generate text/email/

telephone calls/messages to up to 6 key holders.

A monitoring service provider is required to make

use of these features.

IMPORTANT: to set up monitoring follow REMOTE

MANAGER instructions.

The system telephone dialler can be set up as a

Voice Dialler that can be used to call for help and

or/notify the user that the system has been triggered

and an alarm has occurred.

In this mode the system will call for help using

your recorded message and dial up to 4 telephone

numbers and replay the corresponding alarm

message for each number. Switching the system

between

Remote Manager to Voice Dialler is

straightforward.

1 2 3 4 5 6 7 8 9 10 11 ... 63 64

Comentários a estes Manuais

Sem comentários

Response SL5 Manual de Instruções Página 6

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Response SL5