Response SL5 Manual de Instruções descarregar pdf (Página 54)

The dialler sequence can be stopped early by either…

a. All numbers have been dialled three times

b. The system is disarmed

c. A call is acknowledged by the recipient

pressing the button on the telephone

keypad.

Note: The line status warning will not operate if the

voice dialler is disabled.

The ‘Cancel/Abort’ signal must only be sent if

a. the dialler has successfully communicated

the alarm event to the AMS, or

b. the system is disarmed within 10 minutes

of the last alarm event being successfully

communicated to the AMS.

SIREN SERVICE / OPERATING MODE

In order to remove the Solar Siren from the wall to

change the batteries, it is necessary to place the

Siren into Service mode to prevent the Tamper

switch on the Siren operating and triggering an

Alarm. When you have completed any alterations to

the system you must remember to switch the Siren

back into Operating Mode.

The Siren can be switched between Service and

Operating modes using either the Remote Control or

Control Panel as follows:

Remote Control:

Press and hold the button on the Remote

Control for approx. 6 seconds.

Control Panel:

With the system in Standby with the Power LED ON:

Press

to enter Test Mode.

Use and buttons to scroll through the

available options until ‘Wirefree Siren Service

ON/OFF’ is displayed.

Press .

The mode into which the Siren is switching will

be indicated as follows:

Service Mode: The siren will produce two short

beeps followed 1 second later by a single long

beep. The Siren LEDs will flash together in

conjunction with the beeps.

Operating Mode: The siren will produce a

single long beep followed 1 second later by two

short beeps. The Siren LEDs will flash together

in conjunction with the beeps.

Press to return to Standby mode.

BATTERY MONITORING

Low battery condition

All system devices continuously monitor their battery

condition. When a low battery indicator is activated,

the battery for that device should be replaced as

soon as possible.

In addition if any PIR or Door/ Window Detector has a

low battery status it will be recorded by the Control

Panel and a message stored in the Event Log.

In addition a low battery status on any PIR or

Door/Window Detector will be recorded by the

Control Panel and stored in the Event Log.

Note: Before removing the battery cover on any

device to replace the battery ensure that the system

is put into Test mode to avoid initiating a Full Alarm.

The low battery indication built into each system

device is as follows:

Control Panel:

During a period of mains supply interruption

the Control Panel will be powered by the

rechargeable backup batteries.

Under normal battery conditions the Power LED

on the panel will flash at 1 second intervals.

However, under low battery conditions the Power

LED will flash at 3 second intervals

Remote Control:

When the Remote Control is operated under low

battery conditions the transmit LED will continue

to flash after the button has been released.

Under normal battery conditions the LED will

extinguish within 2 seconds of the button being

released.

ENTER

, ,

User Access Code

ESC

ENTER

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 63 64

Comentários a estes Manuais

Sem comentários

Response SL5 Manual de Instruções Página 54

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Response SL5